W7x User Manual
36
NETWORK SETTING
802.11 Mode: Choose the setting that corresponds to the type of wireless clients connected to your
network: B, G, N, B/G or B/G/N (on the 2.4GHz) or A, N or A/N (on the 5GHz). If you aren’t sure which
type(s) of clients will access the wireless networks, it’s recommended to choose B/G/N Mixed (on the
2.4GHz) or A/N Mixed (on the 5GHz) for best performance.
NOTE: When set to a mixed mode ALL devices connected to the wireless will use the mode that is
compatible for ALL devices. Example – If you have the 2.4GHz Wireless set to B/G/N Mixed and a devices
connects using G, all devices will be connected at G speed.
SSID: If you know the SSID you want the client bridge to associate with, you can type it under Specify the
static SSID. For easier setup, click on “Site Survey” and a list of available SSID’s will show up and you can
select the appropriate one.
Site Survey: Click “Site Survey” to perform an automatic site survey. A new window will display the results
of the site survey. (See the figure below.) The W7x will scan the 2.4GHz frequency for devices currently
broadcasting their SSIDs, and display them in the 2.4GHz Site Survey table shown below. In the table, click
the BSSID of the Access Point you wish to connect to.
Click “Refresh” to re-scan the frequency.
To Next Page
Loading...
