W7x User Manual
19
Name: Type a user name.
Password: Type the current password.
New Password: Type the new password, maximum 12 characters.
Confirm New Password: Type the password again.
Click Apply to save your changes.
NOTE: For any changes to take effect, you must click the “Save Changes” button on the lower left below the menu.
This will reboot the access point, applying the configuration changes.
MAINTENANCE
Under the System section in the W7x main menu, click “Maintenance”. When The Maintenance page
appears, you can save the current settings for the W7x. This is useful when, for example, you need to configure
several devices with the same settings.
Backup Current Configuration: Click “Backup” to save the current configuration.
Restore Configuration: If you have already backed up your W7x configuration, you can quickly restore it.
Click “Browse” and choose the backup file, then click “Restore”.
Reset to Factory Default: Click “Factory Default” to reset the W7x to the factory default settings. After
the device restarts, you can access the W7x at the default IP address: 192.168.1.250 and login: pakedge /
pakedgea
To Next Page
Loading...
