Pakedge Device & Software W7 SERIES - Page 23

W7x User Manual
23
 Enable/Disable: To manage the W7x remotely using an SNMP manager, select “Enable”.
 Contact: Enter the contact information for the SNMP manager.
 Location: Enter the location of the W7x for reference by the SNMP manager.
 Community Name (Read only): Type the password for read-only access to the SNMP community.
 Community Name (Read/Write): Type the password for read/write access to the SNMP community.
 Trap Destination Address: Type the IP address to receive SNMP traps.
 Trap Destination Community Name: Type the password of the SNMP trap community.
 SNMPv3: Select v3Enable for added encryption, if your manager supports SNMPv3.
 User Name: Enter the user name for the SNMP manager with permission to access the W7x.
 Authorization Protocol: Select the encryption type that the SNMP manager is using for the login
information.
 Authorization Key: Enter the pass key that the SNMP manager will use to login to the W7x’s SNMP agent.
 Click “Apply” to save your settings.