Chapter 2 Safety and Health Standards
Required minimum distances
The crushing point for the parts of the body specified above are not considered to be dangerous
locations provided that the specified safety distances are not undershot. It must also be ensured that
the next biggest part of the body cannot get into the crushing point.
Risk of burns
Some components can become extremely hot during operation (lines, hoses, valves, valve operating
levers, hose connections, hydraulic cylinders, oil motors, pumps etc.).
Contact with these parts can cause burns!
Risk of scalding if oil escapes!
No smoking!
No naked flame!
Noise emission
Warning! Permanent low or short high noise emission levels
endanger the health of operators and bystanders.
Operators have to comply with the relevant national noise control standards and laws.
After maintenance, service and repairs
Note!
Every time after maintenance, repair or service it is absolutely
necessary to check the function of all safety equipment on the device
(stand ard and optional)!
To Next Page
Loading...