Emergency operation after remote control failure
Remove the battery and insert the charged spare battery. Charge the battery you removed
immediately.
If it is still not possible to operate the crane via remote control, connect handset and receiver as shown
below.
If the remote control still does not work:
Set the key switch to manual operation.
Operate the crane from the emergency operator station. Any loading and unloading can be finished.
Contact your PALFINGER partner.
Danger! If the operator cannot observe the crane movements or the
lifted load from the crane's emergency operator station, there is
severe risk of fatal injury.
If it is not possible to fully observe all
crane movements and the resulting load path;
loads;
from the emergency operator station during support and/or crane operation, the operator must be given
signals by a qualified signaller.
To Next Page
Loading...