Chapter 7 Preparing for crane operation
Attach lower load block
At the remote control handset deactivate RTC. Slacken the rope until the slack rope device responds.
1. Disassemble the rope thimbles
2 From the top pull the rope into the lower load block (1) and
pin it (2), attach the securing pin (3)!
At least 1 meter of rope must be free.
Lower load block attached
It is not allowed to work without lower load block (except with workman basket), because only this
weight ensures correct rope winding.
To disassemble the lower load block follow the steps above in reverse order.
To Next Page
Loading...