22 Section 1C: Connecting to Your Computer
Connecting Your Treo 650 to Your Computer
1. Plug the AC charger into a wall outlet.
2. Plug the USB sync cable into an available USB port or a powered USB hub on
your computer.
3. Connect the sync cable to the Multi-connector on the bottom of your
Treo 650 with the HotSync® button facing up. Do not press the HotSync
button until you are instructed to do so.
Important:
If you’re upgrading from another Palm Powered device, follow the
upgrade steps on page 251 before you set up your computer for your new
Treo 650
.
To Next Page
Loading...
