Table of Contents
1 Unit Functions and Restrictions..........................................................1-1
1.1 Unit Functions and Operation .............................................................1-2
1.2 Basic Operation of Analog Output Processing ...................................1-3
1.2.1 Analog Output Processing ............................................................... 1-3
1.3 Restrictions on Units Combination......................................................1-4
1.3.1 Limitations on the Power Consumption ........................................... 1-4
2 Names and Functions of Parts ............................................................2-1
2.1 Analog Output Unit..............................................................................2-2
3 Wiring.....................................................................................................3-1
3.1 Wiring of Terminal Block .....................................................................3-2
3.2 Analog Output Connections................................................................3-3
3.2.1 Voltage Output (-10 to +10V, 0 to +10V, 0 to +5V, and +1 to +5 V).. 3-3
3.2.2 Current Output (0 to +20 mA and +4 to +20 mA)............................. 3-3
4 Unit Settings and Data Writing ............................................................4-1
4.1 Confirming the I/O Number Allocations and First Word Number ........4-2
4.1.1 Occupied I/O Area and I/O Allocations ............................................ 4-2
4.1.2 Confirming the I/O Number Allocations............................................ 4-3
4.1.3 Allocations to unit............................................................................. 4-3
4.2 Configuration Settings.........................................................................4-5
4.2.1 Configuration of Analog Output Unit ................................................ 4-5
4.2.2 Setting method................................................................................. 4-5
4.2.3 Settings ............................................................................................ 4-6
4.2.4 Unit Setting and Conversion Processing Time................................. 4-6
4.3 Writing Analog Output Data ................................................................4-8
4.4 Timing Chart of Output Processing.....................................................4-9
5 Conversion Characteristics of Analog Output...................................5-1
5.1 Voltage Range ....................................................................................5-2
5.1.1 Voltage Output Range: -10 to +10 V (0.32 mV, 1/62,500) ............... 5-2
5.1.2 Voltage Output Range: 0 to +10 V (0.32 mV, 1/31,250)................... 5-3
5.1.3 Voltage Output Range: 0 to +5 V (0.16 mV, 1/31,250)..................... 5-3
5.1.4 Voltage Output Range: +1 to +5 V (0.16 mV, 1/25,000)................... 5-4
5.2 Current Range ....................................................................................5-5
5.2.1 Current Output Range: 0 to +20 mA (0.64 μA, 1/31,250) ................ 5-5
5.2.2 Current Output Range: +4 to +20 mA (0.64 μA, 1/25,000) .............. 5-5
6 Option Settings for Analog Output .....................................................6-1
6.1 Offset / Gain Processing Settings.......................................................6-2
6.2 Scale Conversion Settings..................................................................6-4
6.3 Settings for Upper and Lower Output Clipping ...................................6-5
WUME-FP7AOH-03
vii
To Next Page
Loading...