Panasonic AJ-PX380G - Confirmation of Return Video Signal in the Viewfinder; Switching to the HDMI Output

– 108 –
Chapter 4 Shooting — Convenient shooting functions
Conrmation of return video signal in the viewnder
The return video signal input to the <SDI OUT2/IN> terminal can be checked in the viewnder while the <USER MAIN>/<USER1>/<USER2> button or
the <RET> button on the lens is held down.
To operate this function, select [SDI IN] in the main menu → [IN/OUT SEL] → [SDI OUT2/IN SEL], and assign [CAM RET] to the button to be used with
the main menu → [USER SW].
@@
NOTE
t Input the same signal as the one set in [LINE&FREQ] of the camera. The return signal cannot be viewed when the signal is 1080/59.94p or 1080/50p.
t When the signal is 1080/23.98PsF, the return signal cannot be checked during playback or recording check.
Switching to the HDMI output
The HDMI monitor can be used for various usage when the output signal of the <HDMI> terminal is switched with the main menu → [IN/OUT SEL] →
[HDMI OUT SIGNAL].
f [MON]: Can be used as the normal monitor output.
f [VF]: Outputs the same signal as the one from the <VF> terminal. It can be used as the external viewnder.
f [SDI IN]: The return video input to the <SDI OUT2/IN> terminal can be viewed constantly. To operate this function, select [SDI IN] in the main menu →
[IN/OUT SEL] → [SDI OUT2/IN SEL].
@@
NOTE
t Even when [VF] or [SDI IN] is set, the playback signal is output during playback or recording check.
t When [LINE&FREQ] is set as 1080/23.98PsF, the return signal cannot be checked during playback or recording check.