Panasonic AJ-PX380G - Operation of the Camera When [BS DIRECT MODE] Is Operating

– 189 –
Chapter 9 Connecting to External Devices — Connecting the base station (AG-BS300P/AG-BS300E)
r Relay cable specication (connection example when the INCOM head set is 5-pin connector)
GND
TALK
RECEIVE
GND
RECEIVE
1
2
4
3
5
GND
TALK (C)
TALK (H)
1
3
2
RECEIVE
RECEIVE
GND
R
L
G
R
LGND
a
c
b
HA216P-5S (71)
Manufacturer Parts No.
(Hirose Electric Co.)
HA216P-3S (71)
Manufacturer Parts No.
(Hirose Electric Co.)
1 wire shielded line
200 mm or shorter
2 wire shielded lines
3 pole pin plug
a: Connect to the INCOM headset
b: Connect to the <AUDIO IN CH1/3> terminal or the <AUDIO IN CH2/4> terminal
c: Connect to the <PHONES> terminal
Operation of the camera when [BS DIRECT MODE] is operating
r Video signal
f <GL IN/VIDEO OUT> terminal: Gets set to [VIDEO OUT]. Setting with the main menu → [IN/OUT SEL] → [GL IN/VIDEO OUT SEL] is not possible.
f <SDI OUT2/IN> terminal: Gets set to [SDI IN]. Setting with the main menu → [IN/OUT SEL] → [SDI OUT2/IN SEL] is not possible. The main menu →
[SYSTEM MODE] → [REC SIGNAL] is set to [CAM], and the signal input to the <SDI OUT2/IN> terminal will be used as the genlock and the return
signal.
r Audio signal when [INCOM] is set to [ON]
f Recording and output: Audio channels 1 and 2 are recorded and output. Recording and output of the audio channels 3 and 4 are not possible.
f <AUDIO IN CH1/3> terminal or <AUDIO IN CH2/4> terminal: This will be the audio input for the INCOM headset. This cannot be recorded.
f Microphone input power switch for <AUDIO IN CH1/3> terminal or <AUDIO IN CH2/4> terminal: These are disabled regardless of the switch position.
r <USER> button
f <USER MAIN> button: Sets to [CAM RET]. The return signal can be checked in the viewnder while the button is pressed.
f <USER1> button: Sets to [BS CALL]. Tally lamp of AG-BS300P/AG-BS300E lights up while the button is pressed.
f <USER2> button: Sets to [TALK]. By pressing the button to enable, the INCOM headset microphone is enabled and talking to the AG-BS300P/
AG-BS300E side becomes possible.
@@
NOTE
t The <USER MAIN> button and the <USER1> button on the remote control unit (AJ-RC10G) or the extension control unit (AG-EC4G) connected to
AG-BS300P/AG-BS300E can be set by the main menu → [USER SW].
t Switching between the scene les 1 to 3 can be performed with the <USER1>/<USER2>/<USER3> button on the remote operation panel
(AK-HRP200G).
t It will be as follows when the <TALLY/CALL> button of AG-BS300P/AG-BS300E is pressed.
- The tally lamp of the viewnder, the back tally lamp and the rear tally lamp of the camera is illuminated.
- The green tally lamp will also illuminate when the viewnder with a green tally lamp is used.
- [TALLY/CALL] is displayed in the viewnder for several seconds.
- The [TALLY/CALL] display will blink while the SmartUI backlight is illuminated.