Panasonic AJ-PX380G - Formatting a P2 Card

– 120 –
Chapter 5 Playback — Thumbnail operations
r [TYPE1] (factory settings)
Status of clip metadata [USER CLIP NAME] to be recorded
When clip metadata has been loaded Uploaded data
When no clip metadata has been loaded, or when setting disables recording of loaded clip
metadata
Same as [GLOBAL CLIP ID]
r [TYPE2]
Status of clip metadata [USER CLIP NAME] to be recorded
When clip metadata has been loaded
Uploaded data + [COUNT] value*
When no clip metadata has been loaded, or when setting disables recording of loaded clip
metadata
Same as [CLIP NAME]
* The [COUNT] value is indicated as a four-digit number.
The [COUNT] value is incremented each time a new clip is generated, if the clip metadata has been loaded and [TYPE2] has been selected as the recording
method.
The [COUNT] value can be reset using the following method.
When you select [PROPERTY] in the main menu → [RECORDING SETUP] → [REC META DATA] and then select [USER CLIP NAME], the following screen is
displayed. Move the cursor over [COUNT RESET], and press the <SET> button to reset the [COUNT] value to 1.
Selecting the [CARD SERIAL] recording
When [ON] is selected in the main menu → [RECORDING SETUP] → [REC META DATA] → [CARD SERIAL], the function that records the serial
number of the P2 card as metadata (text memo without offset) is enabled.
Initializing the metadata setting
Select [INITIALIZE] in the main menu → [RECORDING SETUP] → [REC META DATA]. Select [YES] when the conrmation screen is displayed.
The settings in the main menu → [RECORDING SETUP] → [REC META DATA] and later items, including loaded metadata, are initialized.
Setting metadata display language
When [NTSC (J)] is selected for the region of use, the language used to display metadata can be set.
Select [LANGUAGE] in the main menu → [RECORDING SETUP] → [REC META DATA], select the display language, and press the <SET> button.
For a language, select either [ENGLISH] or [JAPANESE].
@@
NOTE
t Characters that cannot be displayed in English are not displayed properly but are displayed as “*”.
t Only alphanumeric characters can be entered.
Formatting a P2 card
1
Open the thumbnail screen and select [FORMAT] in the main menu → [CLIP].
f Select the slot number where the P2 card to be formatted is inserted, and press the <SET> button.
f Select [EXIT] when you do not wish to format the card.
2
Use the cursor buttons to select [YES].
The selected P2 card is formatted.
@@
NOTE
t Data deleted as a result of formatting cannot be restored. Always check the data before formatting.
t If the CPS password has been set, the conrmation message whether to select the encrypted format [CPS(ENCRYPT)] or normal format [NORMAL] is
displayed when selecting a slot. When the encrypted format is selected, the microP2 memory card is encrypted.