Panasonic AJ-PX380G - Page 119

– 119 –
Chapter 5 Playback — Thumbnail operations
*2 When entering [MEMO], make sure to enter [TEXT]. It is not possible to record only [PERSON] (the person inputting the memo), or [OFFSET] (the recording
position).
@@
NOTE
t Files which were not edited by P2 Viewer Plus are displayed as [UNKNOWN DATA!] and may not be readable.
Loading clip metadata (metadata upload)
Fig. 1 Fig. 2
1
Insert the SD memory card that contains the clip metadata (metadata upload file).
2
Select [LOAD] in the main menu → [RECORDING SETUP] → [REC META DATA].
The metadata name of the metadata upload le on the SD memory card is displayed. (Fig. 1)
3
Use the cursor buttons to select the file to be loaded, and select [YES].
f Upload starts.
f Uploaded metadata is retained even if the power is turned off.
f For conrmation of uploaded data, refer to “Checking and modifying uploaded metadata” (page 119).
@@
NOTE
t While displaying metadata names, press the cursor button (I) to switch to le name display. (Fig. 2)
Press the cursor button (Y) to return to metadata name display.
Checking and modifying uploaded metadata
Details of metadata uploaded from an SD memory card can be checked.
Fig. 1 Fig. 2
1
Select [PROPERTY] in the main menu → [RECORDING SETUP] → [REC META DATA].
The metadata list is displayed.
2
Use the cursor buttons to move the cursor over the item to be checked, and press the <SET> button.
Settings of the uploaded metadata can be checked. (Fig. 1)
3
While checking the settings for the metadata, use the cursor buttons to move the cursor over the item where you want to change
the setting, and press the <SET> button.
f A software keyboard screen is displayed, allowing you to modify the setting. (Fig. 2)
f While holding down the <SHIFT> button, press the cursor buttons (`/{) to move to the beginning or end of the setting details to be changed.
Setting whether to record the uploaded metadata
Set [ON]/[OFF] in the main menu → [RECORDING SETUP] → [REC META DATA] → [RECORD]. [OFF] is set in the factory settings.
Selecting the [USER CLIP NAME] recording method
Select the [USER CLIP NAME] recording method from the two of [TYPE1] and [TYPE2] in the main menu → [RECORDING SETUP] → [REC META
DATA] → [USER CLIP NAME].