Panasonic AJ-PX380G - Page 198

– 198 –
Chapter 10 Network Connection — Network settings
[DHCP SERVER]: Setting whether to use the DHCP SERVER function ([ENABLE]: Uses the DHCP SERVER function/[DISABLE]: Does not use
the DHCP SERVER function) (Factory setting: [DISABLE])
2
Select [LAN] in the main menu → [NETWORK SETUP] → [NETWORK SEL].
3
Configure the settings of wired LAN of your computer.
(For Windows)
Display [Properties] in [Internet Protocol Version 4 (TCP/IPv4)] and congure the settings. For details on how to display the screen, refer to [Start] →
[Help and Support].
f When [DHCP SERVER] is set to [ENABLE] on the camera
Select [Obtain an IP address automatically] and [Obtain DNS server address automatically] in the [General] tab. Select [Automatic private IP
address] in the [Alternate Conguration] tab.
f When [DHCP SERVER] is set to [DISABLE] on the camera
In the [General] tab, select [Use the following IP address], and enter the following items.
- [IP address]
- [Subnet mask]
- [Default gateway]/[Preferred DNS server]/[Alternate DNS server]: Not necessarily to be entered.
(For Mac OS)
f When [DHCP SERVER] is set to [ENABLE] on the camera
[Congure IPv4]: Select [Using DHCP].
[Congure IPv6]: Select [Automatically].
f When [DHCP SERVER] is set to [DISABLE] on the camera
[Congure IPv4]: Select [Manually] and enter the following items.
- [IP Address]
- [Subnet Mask]
- Entering [Router] is not required. Leave it blank.
[Congure IPv6]: Select [Automatically].
@@
NOTE
t The startup time after turning on the power may be longer due to starting of the network.
t When you change the settings of [NETWORK SEL], the changes will not be reected until the camera is restarted. After the settings have been
changed, the setting screen termination may take time due to the restart of the network service.
t All of the IP address, subnet mask, and default gateway must be correctly set.
If a warning [CANNOT ACCESS GATEWAY!] appears at the termination of the setting screen, contact the administrator of the network you use.
t If you do not use default gateway and DNS, set them to [0.0.0.0].
t DHCP and DNS may not function properly depending on the network environment.