– 215 –
Chapter 11 Maintenance — Warning system
Message Description Measure
[LACK OF CAPACITY!] Not enough space left on the storage device.
Use a new storage device with sufcient available space
or a formatted storage device.
[MISMATCH COMPONENT!]
The P2 card model number of the copy source and copy
destination do not match. Cannot copy.
Use the P2 cards of the same model number, or import
on a clip basis.
[STORAGE DEVICE DISCONNECTED!] The connection with the storage device is disconnected.
Reconnect the USB cable to the <USB2.0> terminal
(host). When it does not function normally after that, turn
off the power once and turn on the power again.
[TOO MANY PARTITIONS!] There are too many partitions.
The maximum number of partitions on the storage
device is 23. Either reformat, or use a new storage
device.
[UNKNOWN DEVICE CONNECTED!]
A non-compatible DVD drive or other device is
connected.
Change the connected device to the correct storage
device, and then turn off the power once and turn on it
again.
[VERIFICATION FAILED!] The compare check performed after copying failed. Copy it again.
Network
Message Description Measure
[CANNOT CONNECT!] A connection to the network cannot be established.
Check that the LAN settings are correct. Check that the
LAN cable is connected correctly and the network you
use is running.
[CANNOT FIND FTP-SERVER!] The connection destination FTP server cannot be found.
Check that the setting in the main menu → [NETWORK
SETUP] → [FTP CLIENT SERVICE] → [SERVER URL]
is correct.
[LOGIN FAILED!]
Logging in to the connection destination FTP server
failed.
Check that the settings in the main menu →
[NETWORK SETUP] → [FTP CLIENT SERVICE] →
[LOGIN USER] and [LOGIN PASSWORD] are correct.
[PING FAILED!] The [PING] failed.
Check that the LAN setting and the setting in the
main menu → [NETWORK SETUP] → [FTP CLIENT
SERVICE] → [SERVER URL] are correct. Check that
the LAN cable is connected correctly and the network
you use is running.
[CANNOT ACCESS GATEWAY!] The gateway server cannot be accessed. Check that the LAN settings are correct.
[CHECK LAN SETTING] The gateway server cannot be accessed. Check that the LAN settings are correct.
[IP ADDRESS IS USED!] The set IP address is being used by another device.
Consult your network administrator and set another IP
address.
[INVALID VALUE!] The entered data value is invalid. Enter data in a valid range.
[ENCRYPTION IS NOT SUPPORT!] Encryption is not supported. Check the encryption setting on the destination.
To Next Page
Loading...
