Panasonic AK-HRP1005G

40 CAMERA IP SETTING
ヒチバチペペ
ヤモヮユンモチリヱチヴユヵヵリワヨ
ヤモヮヒチチリヱチチモュュンユヴヴ
ビ
ヱヰンヵ
ピ
ヶヱロヰモュ
ヒ
フ
ヤモヮヒチチリヱチチモュュンユヴヴ
ヒペビヒプベパ
ビパ
フペヒブビ
ドㄑㄖㄔㄉナ
ビチバチペペ
ヤモヮユンモチリヱチヴユヵヵリワヨ
ヤモヮビチチリヱチチモュュンユヴヴ
ビ
ヱヰンヵ
ピ
ヶヱロヰモュ
ヒ
フ
ヤモヮビチチリヱチチモュュンユヴヴ
ヒペビヒプベパ
ビヒ
フペヒブビ
ドㄑㄖㄔㄉナ
ヤモヮユンモチリヱチヴユヵヵリワヨ
ヤモヮペペチチリヱチチモュュンユヴヴ
ビ
ヱヰンヵ
ピ
ヶヱロヰモュ
ヒ
フ
ヤモヮペペチチリヱチチモュュンユヴヴ
ヒペビヒプベパ
ヒヒベ
フペヒブビ
ドㄑㄖㄔㄉナ
ペペチバチペペ
Item Setting details
CAM1 to CAM99 IP
ADDRESS
Sets the IP address of the camera.
The setting ranges are as follows.
(IP addresses are assigned in order starting with 192.168.0.20 for CAM1 under factory default con-
ditions.)
1st octet: 1 to 223
2nd octet: 0 to 255
3rd octet: 0 to 255
4th octet: 1 to 254
However, the following addresses cannot be set.
Check the setting values during configuration.
0.*.*.*, *.*.*.0, *.*.*.255, 127.0.0.1
Class D address (224.0.0.0 to 239.255.255.255)
Class E address (240.0.0.0 to 255.255.255.255)
CAM1 to CAM99 PORT Sets the port of the camera.
Values from 1 to 65535 can be set.
(Factory default: 49152)
CAM1 to CAM99 INF
UPLOAD
When you press the menu operation dial, the camera's IP address and port will be set.
NOTE
Performing [UPLOAD] after changing the settings will apply the setting value changes. Perform [UPLOAD] on each screen. The
settings will not be applied unless [UPLOAD] is performed.
- 117 -
ROP menu