Panasonic AK-HRP1005G

7 [KNEE] button Use this button to display the knee menus.
The menus will switch with each press of the button.
[KNEE] [WHITE CLIP] menu off (status screen)
“17 KNEE” (see page 80)
“18 WHITE CLIP” (see page 81)
Status displays
Lit
green:
The current value matches that configured in the reference file.
Lit
red:
The current value does not match that configured in the reference file.
Off: Comparison with reference file values is not possible, as the reference file could not
be loaded.
To load a reference file:
The following two methods are available.
n Use the [REF.RECALL] button to load a reference file.
The reference file settings will be applied to the CCU settings.
n Execute [REFERENCE] > [REF.DL EXEC] in the ROP menu.
The reference file data will be loaded to the ROP. However, the reference file
settings will not be applied for the camera and CCU.
8 [DTL] button Use this button to display the HD detail and UHD detail menus.
The button functions will switch with ROP menu setting.
When the [ROP SETTING] > [DTL BUTTON] setting is “HD”:
Use this button to display the HD detail menus.
The menus will switch with each press of the button.
[HD DETAIL] [HD SKIN TONE DTL] [DNR] menu off (status screen)
“20 HD DETAIL” (see page 83)
“23 HD SKIN TONE DTL” (see page 88)
“28 DNR” (see page 98)
When the [ROP SETTING] > [DTL BUTTON] setting is “UHD”:
Use this button to display the UHD detail menus.
The menus will switch with each press of the button.
[UHD DETAIL] [UHD SKIN TONE DTL] [DNR] menu off (status screen)
“21 UHD DETAIL” (see page 85)
“24 UHD SKIN TONE DTL” (see page 90)
“28 DNR” (see page 98)
When the [ROP SETTING] > [DTL BUTTON] setting is “SD”:
Use this button to display the SD detail menus.
The menus will switch as follows with each press of the button.
[SD DETAIL] [DNR] menu off (status screen)
“22 SD DETAIL” (see page 87)
“28 DNR” (see page 98)
Status displays
Lit
green:
The current value matches that configured in the reference file.
Lit
red:
The current value does not match that configured in the reference file.
Off: Comparison with reference file values is not possible, as the reference file could not
be loaded.
To load a reference file:
The following two methods are available.
n Use the [REF.RECALL] button to load a reference file.
The reference file settings will be applied to the CCU settings.
n Execute [REFERENCE] > [REF.DL EXEC] in the ROP menu.
The reference file data will be loaded to the ROP. However, the reference file
settings will not be applied for the camera and CCU.
- 27 -
Parts and their functions