- 36 -
You can enable/disable the digital zoom (zoom level maximum: k4).
∫ Setting Using the Camera Menu
≥ The larger the digital zoom magnification, the more the image quality is degraded.
“Enable” or “Disable” is set here for the function which turns on/ turns off the tally lamp using
the tally control signal.
∫ Setting Using the Camera Menu
You can select whether to show/hide messages such as [AWB OK], which is displayed when
performing the white balance setting ([AWB A]/[AWB B]).
∫ Setting Using the Camera Menu
You can set the camera’s remote control ID.
≥ This function’s default setting is [CAM1].
You can enable/disable the wireless remote controller.
[Digital Zoom]
[Off]/[On]
[SYSTEM] # [D.ZOOM] # desired setting
[Tally Enable]
[Off]/[On]
[SYSTEM] # [TALLY] # desired setting
[OSD Status]
[Off]/[On]
[SYSTEM] # [OSD STATUS] # desired setting
[IR ID]
[CAM1]/[CAM2]/[CAM3]/[CAM4]
[IR Control]
[Off]/[On]
To Next Page
Loading...
