Panasonic CZ-RTC4

12
(EN)
4
Set the program pattern. (Program step 3)
There are 4 program patterns.
Pressing [▼/▲] repeats the following display patterns.
°°
Pattern 1 (Default display)
[▼]
[▼]
Pattern 2
[▲]
[▲]
Pattern 4
[▲][▲]
Pattern 3
[▼][▼]
The indoor unit starts operation at the
programmed time.
The indoor unit starts operation at the
programmed time and changes the
temperature settings.
The indoor unit stops operation at the
programmed time.
The indoor unit changes the
temperature setting at the
programmed time.
For Pattern 3 and Pattern 4: Press [ / ] to change the temperature setting.
5
Select the program pattern and press [SET].
The program timer setting is confi rmed and the unit enters the confi rmation mode
.
Note
 If you press [CANCEL] during the setting, it returns to the program confi rmation
mode.
 If there is no operation made for 10 minutes during the setting, it returns to the
normal mode.
In this case, all the settings in progress will be invalid.