41
Chapter 3 Copier Settings
Example : Manual Skyshot Mode
In the Manual Skyshot mode, the scanning area (size) is pre-registered into memory (M1 and M2) in
advance.This mode also allows copying an original without generating dark borders even if the ADF is
opened.
z An incorrect exposure may occur when there is a black line at the edge of the original.
z The Sort function (Sort, Shift-Sort, Rotate-Sort, and Staple-Sort) is not available in the Manual Skyshot mode.
1
Press the Function key.
2
Select “Copier Settings”.
3
Select “5-9”.
4
Select “09 Manual Skyshot Mode”.
5
Select the desired item, and then
select “OK”.
z For changing M1/M2 size, refer to “M1,
Size” or “M2, Size” (see page 37).
6
Select “Close”.
z Press the Reset key to return the machine
to the initial screen of the current active
mode.
Off The Manual Skyshot mode
is OFF.
M1, On Copies in M1 size.
M2, On Copies in M2 size.
M1, M2, On Copies in pre-registered
size (M1 or M2).
To Next Page
Loading...
