46
Chapter 4 Fax/Email Settings
Fax Parameters
z The contents of Fax Parameter may differ depending on the each country’s regulation or specification.
No. Parameter Comments Selective Item
Standard
Setting
0 - 39 00 Print FaxParameterList Print the Fax Parameter List.
To cancel printing the fax
parameter list, press “Stop” and
“OK”.
While processing the
cancellation, panel operation is
denied, and an error beep is
produced.
The feeding paper(s) will be
ejected before completing the
above cancellation operation.
If setting a parameter, an asterisk
mark (*) will be added before the
parameter number.
Stop, Start Start
01 Density (HOME) Set the default density according
to the most-used original.
-3, -2, -1, 0, 1, 2, 3 0
02 Resolution (HOME) Set the default resolution
according to the most-used
original.
z When installing the optional
Fax Communication Board, the
standard setting can be
changed.
STD, Fine, S-Fine Fine
03 Original (HOME) Set the default of original type
according to the most-used
original.
Text,
Txt/Pht (Text/Photo),
Photo
Te xt
04 Stamp (HOME) When set to “On”, all successfully
transmitted originals are stamped
(Memory or Direct transmission).
In order not to stamp the memory
transmitted originals, set “28
Stamp At Memory XMT” to
“Invalid”.
Off, On Off
05 Memory (HOME) Set the default for Memory
transmission.
When set to “Off”, originals are
transmitted directly without being
stored into memory first.
Off, On On
06 Dialling Method Select a dialling method
according to your telephone line.
z This feature is available in
certain countries only.
Tone , Pul s e Tone
To Next Page
Loading...
