Panasonic Eco Solutions Nordic AB
MEW01622 Rev: - EBL128 Planning Instructions V2.0.x
113
The alarm text can as an alternative be typed (or edited) in the
EBLWin "Text editor" (menu System | Edit Alarm Texts…).
No matter where the text is typed, it will be shown on both places.
Explanations:
Zone-Address column
Shows the already programmed alarm points (e.g. 001-01, 001-02,
002-01 etc.). Only the texts have to be typed / edited in the "Text"
column.
Shows the already programmed zones, i.e. MIO unit 3361 zone line
inputs and 8 zones expansion board 4580 zone line inputs
programmed with address "00" (i.e. ZZZ – 00).
Only the texts have to be typed / edited in the "Text" column.
NOTE!
In system EBL128 is the highest possible zone number 099 since only
two digits can be shown in the display.
Text column
Shows already programmed alarm point / zone texts. Texts can be
typed / edited.
NOTE! If any alarm point shall have a different alarm text in one or
more of the "display units" 1826, 1828, 1735, 1736 or 1728
, the text
Regarding text priority order etc. see Technical Description (chapt. "User
definable text messages") for the "display unit" respectively.
To Next Page
Loading...
