Panasonic EBL128 - Fault Signal (Fault Condition); Alarm Texts; Creating the Alarm Texts Via Eblwin

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: - EBL128 Planning Instructions V2.0.x
112
13.21 Fault signal (fault condition)
Fault signal, fault messages, fault acknowledge, etc. are described in
EBL128 Operating Instructions, chapter "Fault".
Programmable inputs can be used to activate fault signal in EBL128,
see chapter "Programmable inputs", page 63.
13.22 Alarm texts
The alarm texts are shown in case of a fire alarm.
The display in EBL128: On the first row will always be shown the
presentation number for an alarm point and on the second row will
be shown a user definable alarm text for this alarm point, if
programmed via EBLWin.
An example of fire alarm information:
ZONE-ADDR 12-45 █ LAST ZONE 12 █ No.01
User definable alarm text for 12-45
The display Ext. FBPs 1826
114
& 1828, the Alert Annunciation units
1735 & 1736 and the Ext. Presentation unit 1728: The same
information as in EBL128 will be shown, if no other alarm text has
been programmed, see below.
Presentation number
When an alarm point is activated, both the zone number and the
address (ZZ-AA) will be shown.
When a zone line input (e.g. on a 4580 board; address AA=00) is
activated, only the zone number (ZZ) will be shown.
See also EBL128 Operating Instructions, chapter "Fire alarm".
Alarm text
User definable alarm texts with up to 40 alphanumeric characters are
created and downloaded via EBLWin.
Each addressable alarm point and each zone can have an individual
alarm text shown in EBL128 and the same or another alarm texts
shown in each Ext. FBP 1826 / 1828, Alert Annunciation unit 1735 /
1736 and Ext. Presentation unit 1728, since specific texts can be
downloaded in each unit individually.
13.22.1 Creating the alarm texts via EBLWin
In the dialog box for an alarm point (e.g. a detector)
115
, there is a
"Text" field where the alarm text for the alarm point can be typed (or
edited). This is the text that will be shown in the display in EBL128
when this alarm point has activated a fire alarm and as from version
2.0 it will also be shown in the fault message.
114
The information will also be printed if a printer is available in the ext.
FBP 1826.
115
In EBLWin.