Panasonic EBL128 - Page 68

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: - EBL128 Planning Instructions V2.0.x
66
16. Activated input will generate a fault in EBL128. Output with
trigger condition "Extinguishing system fault" will be activated.
The following fault message will be shown:
FAULT: Extinguishing system fault
17. Activated input will light up the LED "Extinguishing" on the
front. (Normally the LED will be lit when a corresponding output
is activated.) Output with trigger condition "Extinguishing system
released" will be activated.
18. Ext. fuses (for the ext. power supply equipment) fault output will
activate a fault in EBL128.
The following fault message will be shown:
FAULT: External fuses
19. Ext. power supply equipment fault output will activate a fault in
EBL128.
The following fault message will be shown:
FAULT: External power supply
20. Activated input will generate a fault in EBL128.
The following fault message will be shown:
FAULT: Fault warning routing equipment
21. A special detector, push button, etc. can activate a fire alarm in
EBL128. Zone no. and Address (+ user definable text).
22. A feed-back from the equipment activated by the corresponding
interlocking output. Activated input is shown in menu H9/C1.
See also chapter "Interlocking function", page 88.
23. Fault output "Loss of the battery charger to external power supply
equipment" will activate a fault in EBL128. It will have the same
time delay, as set for the "Loss of main power source" fault for
EBL128.
The following fault message will be shown:
FAULT: Charging ext. power supply
24. Fault output "Loss of main power source to external power supply
equipment" will activate a fault in EBL128. It will have the same
time delay, as set for the Loss of main power source fault for
EBL128.
The following fault message will be shown:
FAULT: Mains, ext. power supply
25. Default. The input does not work.