Panasonic FP-7818

5-59
Troubleshooting
Code Item Function
(Factory
setting)
UP-22 Auto off timer 0: No auto off timer 1
1: 30 m 2: 60 m
3: 1.5 hr 4: 3 hr
5: 4 hr
UP-23 Auto original density 0: Not detecting 1: Auto mode priority 1
(When power ON) 2: Manual mode priority
UP-24 Message display 0: Japanese 1: English 1
language change 2: German 3: French
4: Italian 5: Spanish
6: Swedish 7: Finnish
8: Dutch 9: Portuguese
UP-25 Auto selection 0: None 0
prohibition paper tray (1) 1: Copier (upper)
2: Copier (lower) (Except FP-7818)
3: System console (upper)
4: System console (middle)
5: System console (lower)
6: LCC (Except FP-7818/7824)
7: Sheet bypass
UP-26 Auto selection prohibition paper tray (2) same as UP-25 0
UP-27 Presentation/ OHP Interleaving mode (0) Blank paper 0
initial setting (1) Copied paper
UP-28 Page Insertion mode initial setting (0) Blank paper 0
(1) Copied paper
UP-29 Cover mode initial (0) Cover page: Blank paper 0
setting (1) Cover page: Copied paper
(2) Cover page: Copied paper
Back cover: Blank paper
(3) Cover page: Copied paper
Back cover: Copied paper
UP-30 Not used
UP-31 Changing upper copy quantity Quantity = 999 + n x 10 + 1 0
(n = -99 to 0)
UP-32 Check width size in M1 memory Width = n x 5mm 28
(n = 1 to 60)
Check length size in M1 memory Length = n x 5mm 43
(n = 1 to 41)
(American)
42
(Others)
UP-33 Check width size in M2 Width = n x 5mm 28
memory (n = 1 to 60)
Check length size in M2 Length = n x 5mm 43
memory (n = 1 to 41)
(American)
42
(Others)