3-2
3.2 Disassembly/Assembly
(1) Replacement of the stapler assembly (FA-S620)
Remove the front cover, right cover, and rear
cover.
1
1 Remove the tie-wrap.
2 Disconnect the connector.
3 Remove the ground wire. (1 screw)
2
3
1 Rotate the stapler swing motor to move
the stapler unit to the position indicated
in the diagram.
2 Remove the stapler unit. (2 screws)
Front cover
Rear cover
Right cover
1
2
3
1
2
To Next Page
Loading...
