5-23
Troubleshooting
(5) F6 mode Adjustment and programming
Set the copier to service mode and press Muiti-Copy key “6”.
Press Print key.
Select desired code number with touch panel display and touch the OK key.
If you wish to select other code number, scroll the menu with arrow keys ( ).
The display will indicate memorized number.
Input the new setting number with Multi-Copy key or Up/Down key.
Increase: Multi-Copy key or Up key of touch panel display
Decease: Reset and Multi-Copy key or Down key of touch panel display
The OK key is touched on the touch panel display, the memory number changed
is now in memory.
When the CANCEL key is touched, the desired code input will not be accepted.
Press Clear/Stop and User Preset key to escape service mode.
Code Item Function Remarks
00 100% selection Adjustment from 99.1% 0.10%
(Ratio of vertical and to 100.9% (–9 to +9)
parallel position to the (+): Enlargement
paper feed direction) (–): Reduction
(standard = 100%)
01 Just 100% (Ratio of Adjustment of ratio for 0.10%
parallel position to the parallel position. (–9 to +9)
paper feed direction) (L/T)
02 100% focus Adjustment of focus. (–50 to +50)
03 Just 100% Adjustment of lens stop (–50 to +50)
(Ratio of vertical position position by lens home (+): Enlargement
to the paper feed direction) position. (S/S) (–): Reduction
04 Original registration Adjustment of original 0.2mm *If you adjust the
detecting timing (Reduction registration detection (–30 to +30) content of F8-02
and Enlargement copying) timing . mode, the content
(+): Delayed of F6-04mode is
(–): Advanced automatically
changed from the
factory setting.
To Next Page
Loading...
