5-58
Code Item Function
(Factory
setting)
UP-00 Paper size (copier and System Refer to example Copier:
Console)
Ledger/A3
System:
Not setting
UP-01 Paper size priority 0:
A4R, LETTER R
1: B4, LEGAL 2
2: A4, LETTER 3: A3, LEDGER
4: INVOICE, A5
UP-02 Margin value default 0: 5mm 1: 10mm 1
2: 15mm 3: 20mm
UP-03 Edge value default 0: 5mm 1: 10mm 1
2: 15mm 3: 20mm
UP-04 Book value default 0: 15mm 1: 20mm 1
2: 25mm 3: 30mm
UP-05 Margin reduction default 0: None 1: 95% 0
2: 93% 3: 91%
UP-06 Sorter mode default 0: None sort 1: Staple sort 0
2: Sort 3: Group
UP-07 Duplex mode default 0: Does not select 1: 1 s
ided to 2 sided
0
2: 2 sided to 2 sided 3: Book to 2 sided
UP-08 2 in 1 copy ratio 0: Full size 1: Reduction 0
UP-09 Auto edge default 0: OFF 1: ON 0
UP-10 Check mode ON/OFF selection 0: OFF 1: M1 ON 0
2: M2 ON 3: M1, M2 ON
UP-11 Manual toner addition (0) OFF (1) ON
UP-12 Total copy usage of a specific Press Print key and input the
department code number.
Changing the total copy Press Print key and input the
usage of a specific code number.
department. Then press Recall key and input
the changed copy usage, and press
Print key.
UP-13 Not used
to 18
UP-19 Set key operator code (3digits)
UP-20 Before setting these modes, please
to 34 input ID number.
UP-20 Auto reset timer 0: None 1: 45 seconds 2
2: 1 minute 2: 1 minute 3: 2 minute
UP-21 Energy saver timer 0: 15 m 1: 30 m 2: 60 m 0
3: 1.5 h 4: 2 h 5: 3 h
6: 4 h 7: No energy saver timer
5.3 User Preset Mode
Regarding the operation procedure, please refer to the operating guide.
To Next Page
Loading...
