3-6
(4) Replacement of the bin unit (FA-S660)
Remove the front cover, right cover, and rear
cover.
1
1 Disconnect the connector of the sorter
controller PCB. ( x 4)
2 Detach the signal code plate. (2 screws)
2
3
1 Remove two screws (front/rear).
2 Lift the guide rail hitch.
3 Place the detached bin unit as shown.
4
Replacing the bin from the upper side
(See 8 for replacing the bin from the lower
side)
1 Place the bin unit sideways on the work
table.
2 Remove the slide rails (front/rear). (2
screws)
3 Remove the bin front cover and bin rear
cover.
(front side: 3 screws, rear side: 4 screws)
Signal code plate
Slide rail
1
2
1
2
3
3
3
3
2
3
To Next Page
Loading...
