3-11
Maintenance
1
ON
23456
*1
1
ON
23456
*1
1
ON
23456
*1
1
ON
23456
*1
1
ON
23456
*1
1
ON
23456
*1
1
ON
23456
*1
1
ON
23456
1
ON
23456
1
ON
23456
1
ON
23456
1
ON
23456
1
ON
23456
1
ON
23456
By turning OFF all the switches, normal
copy condition is set up.
•
By pressing the manual staple key, the
feed motor (M2) rotates in the forward
direction (paper feed direction). To stop,
press the staple start/stop key again.
•
By pressing the manual staple key ( ),
the in-bin paper dtecting sensor (S1, S2)
adjustment mode is executed.
When replacing sorter controller PCB
and in-bin paper detecting sensor
(S1,S2).
•
To adjust the swing range of tamper bar.
When replacing sorter controller PCB,
tamper bar home position sensor and
the bin unit.
By pressing the manual staple key, the
guide bar operates.
Each press causes the operation of A4-R
B5 LT-R A4-R to be repeated. By
pressing the manual staple key again, the
guide bar returns to the home position and
stops.
To adjust the staple position
When disassembling sorter controller
PCB, stapler home position sensor, and
the stapler unit.
Setting
FA-S620 FA-S660
(1) Dip switch function list
Functions of the dip switch (SW1) on the sorter controller PCB are shown in the
table below.
Function
Page
No.
(When A4 copy paper is used)
(When LTR copy paper is used)
(When A4 copy paper is used)
(When LTR copy paper is used)
*1: After adjustment, make sure to turn OFF all the swithces.
To Next Page
Loading...
