Unpacking/
Installation
6-17
Location Procedure
Check
20
Connect the lattice connector of the
sorter to the copier.
21
Attach the "Staple" label.
(1) Open the platen cover (or ADF).
(2) Attach "Staple" label (A) provided
on the upper cover (rear).
(When the ADF is installed)
<FA-A888>
Attach "Staple" label (B) provided on
the main cover.
22
Operation check
(1) Place some paper in the stapler
position on the top bin and press
the manual staple key.
(2) Remove the paper from the bin
and check staple.
(3) When sheets of paper are not
stapled, repeat steps (1) - (2).
(Copier upper rear cover)
<FA-A888>
Staple label (A)
Staple label (B)
A
B
C
A
B
C
To Next Page
Loading...
