- 128 -
To use the Wi-Fi function, connect this unit to a wireless access point or smartphone via Wi-Fi.
∫ About the status indicator and the connection status icon when
connected to Wi-Fi
Connecting to a wireless access point
Check if the wireless access point you are using is compatible with WPS.
j If the wireless access point is compatible with WPS:
Proceed to the following [Easy Connection (WPS)]
j If the wireless access point is not compatible with WPS:
[Manual Connection] (l 130)
≥ WPS is an abbreviation for Wi-Fi Protected Setup™.
∫ If this is the first time the Wi-Fi button is pressed.
1 Press the Wi-Fi button.
2 Touch [YES].
3 Touch [Easy Connection (WPS)].
Wi-Fi [HC-V720]/[HC-V727]/[HC-V720M]
Connecting to Wi-Fi
If the clock has been set for the first time, the confirmation message for the Wi-Fi settings will be
displayed. Touch [YES], and then configure the access point settings below.
A Lit green
≥ The status indicator is lit green while this unit is
connected to a destination device after completing a Wi-
Fi connection.
≥ When Wi-Fi is disconnected, the status indicator is lit red
again.
B The connection status icon
When connected to wireless access point:
connected to Wi-Fi/ not connected to Wi-Fi
≥ The display will change as follows according to the radio
wave intensity: # # # .
When directly connected:
connected to Wi-Fi/ not connected to Wi-Fi
[Easy Connection (WPS)]
To Next Page
Loading...
