- 93 -
Deleting part of a scene (AVCHD)
Unnecessary part of an AVCHD scene can be deleted.
The deleted scenes cannot be restored.
≥ Change the mode to and touch the play mode select icon. Then, select the AVCHD
scene. (l 27)
1 Select the menu.
2 Touch the scene with a part to delete.
3 Set the section to delete by touching and sliding
the top and bottom section selection buttons .
≥ It is convenient to use Slow-motion Playback and Frame-by-
frame Playback. (l 78)
4 Touch [ENTER].
5 Confirm (play back) the scene after editing by touching [YES].
≥ A confirmation message appears when [NO] is touched. Proceed to Step 7.
6 Stop the playback.
≥ A confirmation message appears.
7 Touch [ENTER].
≥ Repeat Steps 2-7 to continuously delete parts from other scenes.
To complete editing
Touch [Return].
≥ Deleting a part of a scene cannot be performed when there are 99 scenes in a single date.
≥ It may not be possible to delete part of a scene with a short recording time.
≥ The scene will be divided into two scenes when the middle part of a scene is deleted.
≥
The relay information is deleted when part of a scene that was relay recorded is deleted, making
it impossible to perform the Relay scene combining. (l 98)
: [EDIT SCENE] # [SECTION DELETE]
MENU
HC-V720M
To Next Page
Loading...
