- 34 -
The unit is put into recording pause approx. 1 second when the unit is turned on with the mode set
to or .
≥ Depending on the recording conditions, start time may be longer than 1 second.
≥ In the Quick Power On Mode, the zoom magnification becomes approx. 1k.
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.
≥ When in Quick Start Standby Mode about 80% of the power used in recording pause mode
is being consumed, so the recording time will be reduced.
≥ //
Quick Start will not work if there is no SD card inserted.
≥
Quick Start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there is no
SD card inserted.
1 Select the menu.
2 Close the LCD monitor.
The status indicator A flashes green and the unit goes into
Quick Start Standby Mode.
≥ The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put into
recording pause.
≥ Quick Start Standby Mode is cancelled if
j about 5 minutes elapsed
j mode is set to
≥ Depending on the recording conditions and menu settings, time for Quick Start may be longer
than 0.6 seconds.
≥ It may take some time for Automatic White Balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes approx. 1k.
≥ When it has gone into Quick Start Standby Mode automatically with the [ECONOMY (BATT)]
(l 33)/[ECONOMY (AC)] (l 33), close the LCD monitor once and open it again.
≥ Turn the unit off using the power button.
[QUICK POWER ON]
: [SETUP] # [QUICK POWER ON] # [ON]
[QUICK START]
: [SETUP] # [QUICK START] # [ON]
MENU
MENU
To Next Page
Loading...
