40
VQT3K43
The unit is put into recording pause approx. 1 second when the unit is turned on with the
mode set to or .
≥ Depending on the recording conditions, start time may be longer than 1 second.
≥ In the quick power on mode, the zoom magnification becomes 1k.
This unit will resume recording pause mode about 0.6 seconds after the LCD monitor is reopened.
≥ Quick start will not work if there is no SD card inserted.
≥ Change the mode to or .
1 Set [QUICK START] to [ON].
2 Close the LCD monitor while the mode is
set to or .
The status indicator A flashes green and the unit
goes into quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is
put into recording pause.
≥ When in quick start standby mode about 80% of the power used in recording pause
mode is being consumed, so the recording time will be reduced.
≥ Quick start standby mode is cancelled if
jabout 5 minutes elapsed
jmode is set to
≥ Depending on the recording conditions and menu settings, the time for quick start may be
longer than 0.6 seconds.
≥ It may take some time for automatic white balance to adjust.
≥ In the quick start mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 39) is set to [5 MINUTES] and the unit automatically goes into quick
start standby mode, close the LCD monitor and then open it again.
≥ Turn the unit off using the power button.
≥ Quick start standby mode cannot be released by the remote control.
[QUICK POWER ON]
[OFF]/[ON]
[QUICK START]
[OFF]/[ON]
HDC-SD800EB_eng.book 40 ページ ２０１０年１２月２４日 金曜日 午前９時９分
To Next Page
Loading...
