VQT3N87 33
Preparation
Setting date and time
1 Select the menu. (l 53)
2 Touch the date or time to be set, then set the desired
value using / .
≥ The year can be set between 2000 and 2039.
≥ The 12-hour system is used to display the time.
3 Touch [ENTER].
≥ The clock is not set when the unit is shipped.
≥ When the unit is turned on for the first time, a message asking you to
set the date and time will appear.
≥ The date and time function is driven by a built-in lithium battery.
≥ If the built-in lithium battery needs to be charged, the message “Set
date and time” appears. To recharge the built-in lithium battery,
connect USB terminal of this unit to a booted PC. Leave the unit as it is
for approx. 24 hours and the battery will maintain the date and time for
approx. 3 months. (The battery is still being recharged even if the unit
is off.)
≥ The date and time will be set to January 1, 2011 00:00 when recording
is performed without the date and time set.
[MENU]
#
# [CLOCK SET]
HM-TA20&TA2_P&PC-VQT3N87_mst.book 33 ページ ２０１１年４月２２日 金曜日 午後１２時１１分
To Next Page
Loading...
