14
- Automation:
- Scene Container is created for Main Scene with example Scenes from the “Templates” folder
assigned to Bus cross-points.
- Background Layer “PGM PST mode” is set to “Next+Loop.” This can be adjusted in the
GUI/Mixer/Scenes page Parameter View panel on the right side under “Layer
Settings”/“Advanced.” Note that the Main scene Background layer must be selected in the
“Layers” panel on the left.
- The example scenes 2Box, 4Box, OTS Left, OTS Right, Title, and Sidecar are derived from the
“Templates” folder created by this “Automation” preset.
- MV1 contains Main-PGM & Main-PVW followed by IN01 - IN08 (style: “10-Split A”).
- MV2 contains IN09–IN24 (style: 16-Split).
- Main consists of BGD + 2 Layers.
- 2M/E:
- Scenes are created for Main Scene, M/E1, and the “Templates” folder is empty.
- MV1 contains Main-PGM & Main-PVW followed by IN01 - IN08 (style: “10-Split A”).
- MV2 contains IN09–IN24 (style: 16-Split).
- Main consists of BGD + 2 Layers.
- M/E’s consist of BGD + 4 Layers.
- 3M/E:
- Scenes are created for Main Scene, M/E1, M/E2, and the “Templates” folder is empty.
- MV1 contains Main-PGM & Main-PVW followed by IN01 - IN08 (style: “10-Split A”).
- MV2 contains IN09 - IN24 (style: 16-Split).
- Main consists of BGD + 2 Layers.
- M/E’s consist of BGD + 4 Layers.
- 4M/E:
- Scenes are created for Main Scene, M/E1, M/E2, M/E3, and the “Templates” folder is empty.
- MV1 contains Main-PGM & Main-PVW followed by IN01 - IN08 (style: “10-Split A”).
- MV2 contains IN09 - IN24 (style: 16-Split).
- Main consists of BGD + 2 Layers.
- M/E’s consist of BGD + 4 Layers.
Note: The “Live view…” function can be used in order to open a new window, enabling monitoring
(stream) of Multiviewer outputs and streams configured via the “Setup/Output Settings” for “RTP.” For
more details, see section 3.3.5.1 Live View.
To Next Page
Loading...
