41
3.3.3.4 Transitions
Picture 3.3.4.1.1
Selected Scene in main folder “Scenes”. Scene “Main” selected.
Layers & default names contained in Scene “Main” indicating ON/OFF (Red) and A/B-Bus availability.
Transition components selected per Transition.
Picture 3.3.4.1.2
When a Transition component is selected, a list of the Transition categories available to that component
is displayed in the “Category” panel. A specific transition can then be selected from the items published
in the effects panel to the right of the categories panel. In this case, only “In/Out Effects” are available
and the “Mix” effect –out of the “Mix In/Out category”– is selected.
Also, a “Parameter View” will show all available modifications for the selected transition type, such as:
manual slider for “Fader” control, Transition “Duration,” the “Mode” for Normal-Reverse run direction,
indicating the current “Direction” of the transition.
In the “Transition Effect Settings,” the “Offset” (Start position) and “Length” (Duration) for selected
Transition can be modified. The “Effect” window shows the selected Transition type.
Transition Name
& Duration
Marker for Transition-Offset (Start) and Transition-Length
To Next Page
Loading...
