87
3.3.9.2 Input Settings
The “Input Settings” GUI menu shows a list of all 32 inputs, each capable of a 3G signal bandwidth, and
the “ ” symbol indicating that at least 1 audio group (ST2110-30) is enabled for this input. When “Delay”
is activated, the indicator appears next to the designated “More” button.
Note: 32 Inputs are accessible only when license AT-SF002 (I/O expansion) is installed. By default,
there are 24 Inputs available.
Each input format is selectable in between ST2110, SDI, NDI, and Stream (Picture
3.3.9.2.2). For “ST2110” input selection, the corresponding high-speed IP address and
“Port” information are required (Picture 3.3.9.2.3 & 3.3.9.2.4) when not handled via NMOS
protocol. The format per input is auto-sensed and displayed (Picture 3.3.9.2.5).
Click the “ ” symbol in order to activate “Video IP” and “Port” settings for adjustments. When finished,
press the keyboard “Return” or “Enter” key, or click on the green symbol to confirm and close.
Only the first input out of a group of 4 can select 4K (indicated with the yellow symbol), in which
case all other inputs in that group will be disabled.
Auto-sensing format UHD “3840 × 2160@59p” for “IN1” in Group 1-4 will disable Inputs 2-4.
“IN02, IN03, IN04” are disabled because of “IN01” UHD format.
Note:
The selection for “ ” is only displayed when the license “AT-SF001” (4K Support) is installed.
To Next Page
Loading...
