36
3.3.3.3.2 “Crop” tool
Select the “Crop” function in the toolbox to activate the Left, Right, Top, and Bottom crop edge controls.
This will only work if the crop function has been enabled. See “Crop Enable” under “Layer Settings”
described on page 38 in this Manual (Picture 3.3.3.3.2.6). When hovering the mouse over the crop
edges, the focused edge can be grabbed with left mouse click and modified.
Positioning the cursor in a corner where 2 edges are connected will focus both adjacent edges (shown
in red) and allow control of the corner cropping when the left mouse is clicked and held down.
To Next Page
Loading...
