13
1.7 Load & Save Production Behavior
KAIROS remembers the last saved state of the system. When using the “Save” or “Save as…” dialog
to save a Production file to an internal or external drive, the KAIROS Core will also save a local copy to
the internal drive to load from after booting the system.
A factory “Default Production” can be re-established by selecting “New ›” from the “Production” drop-
down menu located in the upper left corner of the Kairos Creator GUI. This will open the Production
Template with all factory default settings. Click “Exit” to close the drop-down menu.
Default Production Templates are:
- Empty:
- Only a Main Scene is created.
- Scene “Templates” directory is empty.
- MV1 contains Main-PGM & Main-PVW followed by IN01 - IN08 (style: “10-Split A”).
- MV2 contains IN09 - IN24 (style: 16-Split).
- Main consists of BGD + 2 Layers.
- Basic:
- Main Scene with Scene examples (Templates) assigned to Bus cross-points.
- Background Layer “PGM PST mode” is set to “Swap.” This can be adjusted in the
GUI/Mixer/Scenes page Parameter View panel on the right side under “Layer
Settings”/“Advanced.” Make sure that the Main scene Background layer is selected in the
“Layers” panel on the left before changing “PGM PST mode.” (for details, see Page 7 in section
“1.2.3 Layer”).
- The example scenes 2Box, 4Box, OTS Left, OTS Right, Title, and Sidecar are derived from the
“Templates” directory created by this “Basic” preset.
- MV1 contains Main-PGM & Main-PVW followed by IN01 - IN08 (style: “10-Split A”).
- MV2 contains IN09–IN24 (style: 16-Split).
- Main consists of BGD + 2 Layers.
To Next Page
Loading...
