Panasonic KAIROS - 3.3.8 Config Tab Selection; 3.3.8.1 Aux

77
3.3.8. Config Tab Selection
3.3.8.1 Aux
Aux-2 in cursor focus, indicating “Green”-Tally . Crossbar can be used for instant “Source-selection.”
Parameter selection per Aux-Bus under “Parameter View” in “Auxbus Settings” and “add effect...”
There are 5 methods to change a source for an Aux-Bus:
1. The Aux-Bus drop-down menu in the Kairos Creator menu bar (Picture 3.3.8.1.2),
2. Right-click the selected Aux-bus for a pop-up menu (Picture 3.3.8.1.3),
3. Click the “Set…”-source button in the “Parameter View” GUI section (Picture 3.3.8.1.4),
4. Click the graphic “Crossbar” section at the bottom of the GUI menu (Picture 3.3.8.1.1),
5. Use the “Ctrl+O” keyboard shortcut.
The Input selection dialog will come up next, except when using method 4 (graphic crossbar selection)
as already described in section “3.2.1 Source/Input Selection” starting on Page 21.
Cursor
focus
Crossbar for selected AUX bus
Picture 3.3.8.1.1
Picture 3.3.8.1.2
Picture 3.3.8.1.3
Picture 3.3.8.1.5
Picture 3.3.8.1.4