78
List of existing Input groups. Cursor focus on “Scenes” group.
Available sources in “Scenes” group. Actual selection for Aux-2 = “Main” (surrounded with blue border).
Define selectable Sources per Auxbus (page 21).
Select Source dialog for designated bus (page 21).
Select “Audio source” for designated bus (page 57).
Audio On/Off (“Mute”) for selected Auxbus.
“Volume” control per Auxbus.
Open Channel “Shuffle” dialog (page 48).
“Gain” control for selected Auxbus (page 49).
Adjust “Audio Delay” per Auxbus (page 48).
Audio Metering for designated bus.
“Preview” On/Off per Auxbus LAH-PVW (page 29).
Define Tally signalization.
Enable/Disable single or various “Clean Mask”-Bits
(1-
8) per Auxbus. The “Clear” function will disable
all selections at once. See the next page for details.
“Output resolution” displays the defined “Output
Settings” for a selected Auxbus.
“Source resolution”
identifies the selected Scene
resolution settings.
“Auto fit”
On/Off controls whether or not a selected
Auxbus source is auto-
scaled in order to fit the
specified “Output resolution.” When “Auto fit” is
turned Off, the “Mapping offset” & “Zoom”
controls
are activated to allow positioning and sizing of the
selected source within the output canvas.
“Enable dve”
deactivated will disable all DVE style
effects from the
selected Auxbus in order to
maintain minimum latency.
“Dissolve enabled” (time, effect, & mode) behaves
as already described for “Advanced” settings on
page 32 in this document (Picture 3.3.3.2.13).
A list of default effects for instant use and additional
effects when selecting “ add effect.” See the
page for details.
For more details see individual sections.
To Next Page
Loading...
