42
Picture 3.3.4.1.3
In this example, the selected Transition Component (Layer-1) has the “Preset enabled” (indicated with
“A/B” symbol. This results in 2 separate sections of Transition-Types, visualized in the categories “In/Out
Effects” & “A/B Effects” area (see Page 33 Picture 3.3.3.2.15, section “3.3.3.2 Scenes” in this manual)
“A/B-Effects” showing a mix effect inside the Layer containing, for example, a PiP (“Picture in Picture”)
or OTS (“Over The Shoulder” box).
In addition to having “A/B-Bus” enabled on Layer-1, a separate “In/Out Effect” can be selected to bring
the layer in and out. Combinations (e.g., “In/Out” & “A>B”) are possible as well.
Available Transition Types are:
Picture 3.3.4.1.4
Note: This grouping of selections has been graphically composited and is not available as an actual
GUI menu. However, all Transition types are available as “In/Out Effects” & “A/B Effects.” The selected
“Category” for “User” at the bottom of “Picture 3.3.4.1.4” is User-definable. So, more effects can be
created and added to the list or unwanted effects can be removed.
To Next Page
Loading...
