Panasonic KAIROS - Page 53

53
Note: For all “Color” type operations within the “Painter” GUI, please refer to section “3.2.3 Color
Adjustments” on page 22 in this manual.
Text field for “Sub-
Title” text object.
X/Y position boxes
with d
ragpad and
Size control.
Text options like “Source
options” described in
section “
3.2.2 Source
Options,” starti
ng on page
21
in this manual, allows
entering and editing of
additional or alternative
text elements for the same
text object.
Add object
Delete object
Object position up/down
Normal or Bold style
Italic (cursive) On/Off
Font type selection
Picture 3.3.3.6.19
Picture 3.3.3.6.21
Picture 3.3.3.6.22
Within “GfxLine Settings,” the border style
settings can be adjusted from
Type
(picture 3.3.3.6.21 & 3.3.3.6.22) in
the
drop-down menu. Control “Width”
using
the slider or arrows, or by entering numeric
values in the designated area right next to
the slider controls.
When in “GfxFill Settings,” the method “Solid” is selected, a
single color will be use to fill the selected object
whether it’s a
Text based or a geometric object.
In this case, all other controls (controls surrounded
with an
Orange border) in “GfxFill Settings” are disabled.
The next examples will use a full screen box-
object to illustrate
the controls. Therefore,
“Color” will remain on “White” and
“ColorB” will use “Black.”
Picture 3.3.3.6.23
Fill type is now a
“LinearGradient” using
2 colors.
“Position1” = Start
position
“Position2” = End
position
Operate positions using
numeric entries, arrows,
or
dragpad controls.
Picture 3.3.3.6.24
Picture 3.3.3.6.25
Picture 3.3.3.6.26
Picture 3.3.3.6.27
Fill type is now a
“RadialGradient” using
2 colors.
“Position1” = Center
position
“Position2” = not used
“Outer radius” = Size/Soft
“Inner radius” = Size/Soft
Use slider, numeric
entries,
or arrows for controls.
9Picture 3.3.3.6.20