Panasonic KAIROS - Page 81

81
There are 3 ways to “Rename” Inputs:
Picture 3.3.8.2.2 Picture 3.3.8.2.3
1. The “Input” drop-down menu in the Kairos Creator menu bar can be used,
2. the right mouse click menu at the selected “Input,” or
3. the Keyboard shortcut “F2” on focused item.
All dialogs would be continued as follows:
Picture 3.3.8.2.4 Picture 3.3.8.2.5
Selecting an Input where a VTR is connected will enable additional controls:
Picture 3.3.8.2.6
Selected device type is VTR .
Right mouse click
context menu.
Loaded Clip
External device TMC commands
Clip Timecode position
Clip positioning/shuttle bar
Loop Mode On/Off
Available
Clips on
external
device