92
Outputs 2-4 cannot select a 4K signal. Therefore, there are 2 individual drop-down menus provided to
select the desired/available format (see Picture 3.3.9.3.4).
Picture 3.3.9.3.3
Note: So far, interlace formats are only supported for Inputs
When Output-1 in Group 1-4 is set to any of the provided 4K formats, for example, “3840 × 2160@59p,”
Outputs 2-4 will be disabled (Picture 3.3.9.3.5).
Picture 3.3.9.3.5
Output-1 format selected “3840 × 2160@59p” for 4K.
“OUT2, OUT3, OUT4” are disabled because “OUT1” is set to 4K format “3840 × 2160@59p,”
As described in “3.3.9.2 Input Settings” for IP signals, when an Output is set to IP-Type, the
corresponding “IP-Address” and “Port” number also need to be specified (Picture 3.3.9.3.6).
Click the “ ” symbol in order to activate “Video IP” and “Port” settings for adjustments. When finished,
press the keyboard “Return” or “Enter” key, or click on the green symbol to confirm and close.
To Next Page
Loading...
