Panasonic KV-S1028Y - Self-Signed Certificate Installation; Enabling SSL;TLS and Installing Self-Signed Certificate

Enabling SSL/TLS
1. Launch Configuration Web.
• For details, refer to "8.1 Launch Configuration Web" (page 66).
2. Open the [Network] tab.
3. Click [SSL/TLS].
4. In "Setup", click [Edit].
5. Set "Service" to [On].
6. Click [Submit].
• Turn the unit's power off and then on again.
11.4.2 Installing a self-signed certificate
1. Launch Configuration Web.
• For details, refer to "8.1 Launch Configuration Web" (page 66).
2. Open the [Network] tab.
3. Click [SSL/TLS].
4. In "Create CRT Key", click [Edit].
• You can not create a CRT key if Self-signed Certificate or Security Certificate is enabled.
5. Click [Submit].
• Do not operate the browser until creation of the CRT key is complete. While the CRT key is being
created, screen updates and network communication may be slow.
6. Click [Back].
7. In "Self-signed Certificate", click [Edit].
8. Click [Submit].
9. Click [Back].
10. In "Setup", click [Edit].
11. Set "Service" to [On].
12. Click [Submit].
• Turn the unit's power off and then on again.
11.4.2 Installing a self-signed certificate
107