5.1 About LED
The status of the scanner is displayed by the LED (Red) ( ) and the LED (Green) ( ), as shown in the
table below:
LED (Red) LED (Green) Status
OFF OFF Power OFF
*1
OFF ON Ready mode or Scanning
OFF Blinking (Fast) Warming up
OFF Blinking (Fast, 2 times consecutively) Double Feed Skip mode
OFF Blinking (Fast, 3 times consecutively) Dog-ear detection skip mode
OFF Blinking (Slow) Sleep mode
*2
or Cleaning mode
Blinking (Slow) ON Notification mode
*3
Blinking (Slow) OFF Network Error
*4
ON OFF Error
*5
*1
If the power off feature in sleep mode is enabled, and if no operation is performed for a certain period of time, the scanner will turn
off automatically. Press the power button ( ) of the scanner to turn it on. You can enable/disable the power off feature, and
change the time until the scanner turns off. See "5.3 Menu screen" (page 28).
*2
If no operation is performed for 15 minutes or longer, the scanner will enter sleep mode automatically to conserve energy. Press
any button (except the power button) on the scanner’s operation panel to return to ready mode. The time until the scanner enters
sleep mode can be changed. See "5.3 Menu screen" (page 28).
*3
For details about the notification, check the LCD or User Utility.
*4
For details about the network error, refer to "11.9 Error Codes and Error Messages" (page 115).
*5
For details about the error, refer to "11.9 Error Codes and Error Messages" (page 115).
5.1 About LED
26
To Next Page
Loading...
