4.2 Moving the Unit
When moving the unit, hold the part as shown in the following illustration.
Notice
• Do not hold the feed tray when moving the unit.
• Do not move the unit immediately from a cold place to a warm place. It may cause condensation,
which may damage the unit. Using the unit immediately will cause the document scanning to be
imperfect. To avoid this, clean the inside rollers with a dry and soft cloth, leave the unit in a warm
place for 1 or 2 hours, and then use the unit after you make sure that the inside of the unit has dried.
• Do not place the unit in extremely high temperatures such as near heat sources, etc.
4.2 Moving the Unit
20
To Next Page
Loading...
