108
KX-FLB802CX/KX-FLB812CX/KX-FLB802CXS/KX-FLB812CXS
• There is something wrong with the unit’s modem.
• The other party’s fax machine is busy or has run out of recording paper. Try again.
- “#1”: Paper input tray
- “#2”: Manual input tray
• Recording paper is not installed or the input tray has run out of paper. Install paper.
• Recording paper is not fed into the unit properly. Reinstall paper.
• A recording paper jam occurred inside of the optional input tray. Clear the jammed paper.
• The cable or the computer power cord is not connected correctly. Check the connections.
• The software is not running on the computer. Restart the software and try again.
• The unit is warming up. Wait for a while.
• The other party’s fax machine is busy or has run out of recording paper. Try again.
• The document is jammed. Remove the jammed document.
• Attempted to send a document longer than 600 mm (23
5
/
8
"). Press [STOP] to remove the document.
Divide the document into two or more sheets and try again.
• The recording paper is installed in the manual input tray when trying to copy, recieve faxes or print reports.
Remove the recording paper from manual input tray.
• The drum life is complete. Replace the drum unit immediately.
• The memory is full of received documents due to a lack of recording paper or a recording paper jam. Install
paper or clear the jammed paper.
• The toner life is complete. Replace the toner cartridge immediately.
• The toner life is near to an end. Replace the toner cartridge as soon as possible.
• The top cover is open. Close it.
• A transmission error occurred. Try again.
• The inside of the unit is too cold. Let the unit warm up. Wait for a while.
• The unit is warming up before operation starts. Wait for a while.
• The fax message was printed on paper which is shorter than letter size paper. Use the appropriate size
paper.
DISPLAY MESSAGE CAUSE AND REMEDY
To Next Page
Loading...
